1. PREPARATION
- digging up holes for setting up posts
- hole dimensions should be 30 – 40 cm in diameter and min. 40 cm in depth, the distance between the holes should be 252 cm, at the end of the line even less

2. SETTING UP POSTS
- you need to set up the first post and cast it in place with concrete
- the post can be adjusted to the desired height

3. SETTING UP THE FIRST PANEL
- Fix the panel onto the post, the horizontal and vertical location then have to be checked. The horizontal location is provided through support to the fence panel

4. SETTING UP THE SECOND POST
- the fence needs to be supported with wooden support elements on both sides of the fence; the horizontal and vertical location have to be checked again

5. SETTING UP FURTHER ELEMENTS
- repeat the procedure

6. CASTING IN PLACE WITH CONCRETE
- once the entire fence is set up, all posts have to be cast in place with concrete, the horizontal and vertical location have to be checked again and adjusted if necessary. The support elements should only be removed, when the concrete cures.

The distance between columns can be 2520 mm max.

Fixing fence posts onto a concrete wall with a supporting pedestal – METAL CRADLE

A post with a metal cradle is placed in vertical position. Drill a hole with a diameter of 5 mm through the post and supporting pedestal – metal cradle as picture shows. When drilling holes, be careful to maintain the vertical position of the post. It is also necessary to remove any rasping as it might start to rust. Insert inox pop rivets with a diameter of 5 mm and length of 10 mm, and then rivet it eight times with blind rivet pliers.